Assemble Video

Step 1 Before opening the box

Record the exclusive bike information on the side of the box with your phone. Make sure it is with the correct direction and without serious damage

Step 2 Unpack the E-bike

Open the package and take out all of the parts. Be careful not missing even a little piece of part.

The parts shall include:

Step 3 Unfold the kickstand to make the bike stand up

Step 4 Install the handlebar

4.1 Screw the bolt anticlockwise and remove the parts that we don’t need.

4.2 Install the handle stem on the front fork stem.

4.3 Expose the bolt mounting hole and then screw the bolt tightly with a wrench clockwise.

4.4 Adjust the angle of the handle stem, then lock the quick release to fix the handle stem and the handlebar.

Step 5 Install the front wheel

5.1 Remove the two plastic covers that attached to the tire for hub protection.

5.2 Remove the plastic sheet from the brake caliper.

5.3 Insert the quick release into the front wheel hub axle hole.

Note:There are two springs on the quick release.

5.4 Install the tire axle into the front fork groove. Note: Make sure the brake disc is placed between the two brake pads.

5.5 Fix the nut of front wheel quick release with right hand and screw the quick release handle clockwise with left hand.

5.6 Fold the quick release handle to fix the tire tightly.

Note:Make sure the brake disc of the wheel will not rub the brake pad when it is rotating under the condition of not taking the brake.

Step 6 Install the front fender and headlight

6.1  Install the front fender and headlight on the front fork bridge with matching bolt and nut.

6.2 Screw the nut with wrench to tighten the front fender and the headlight.

6.3 loose the bolt with a wrench to adjust the headlight angle so the light can illuminate the road ahead. Tighten the bolt when the adjustment is done.

6.4 Connect the headlight cable.

Note:Make the two arrows stay in a line when pushing the connector

6.5 Screw the two bolts to fix the side brace of fender.

Step 7 Adjust and tighten the handle stem

Make the handlebar at a 90 degrees angle to the tire and then screw the two bolts tightly.

Step 8 Install the pedals

8.1 The label with a “L” mark indicate it is a left pedal and the label with a “R” mark indicate it is a right pedal.

8.2 Screw the left pedal bolt into the left crank with the wrench anticlockwise.

8.3 Screw the right pedal bolt into the right crank with the wrench clockwise.

Step 9 Inflate the tyres

Check whether the tire beads and tires are evenly seated on the rims.Use a pump with a Schrader valve and pressure gauge to inflate each tire to the recommended air pressure which write on the tire sidewall.

NOTICE: Both wheels must be properly secured before operating your bike. If you are not able to assembly your bike, please contact us or look for some help from a certified, reputable local bike mechanic .Ensure all hardware is tightened properly.

Note: Do not over inflate or under inflate the tire.

Minors are prohibited from riding.